Economy 7 smart meter problems: how to check and fix them

Lots of people have moved to smart meters recently, especially after the old radio-controlled meters were switched off in June 2026. Most changeovers go smoothly, but some people find their Economy 7 isn't working as it should. Here's how to tell, and what to do.

Common Economy 7 smart meter problems

These are the problems people most often report after getting a smart meter on Economy 7:

  1. The meter is set up as single rate. All your electricity, including night use, is billed at one rate, usually the day rate.
  2. Night use is charged at the day rate. Your bill shows little or no night-rate use, even though storage heaters or a hot water tank run overnight.
  3. The cheap hours changed. The new meter's off-peak window is different from the old one, so timers for heaters or hot water no longer line up. Some suppliers say the window can move by around 30 minutes, and some smart meters use a fixed window such as 00:30–07:30.
  4. Heaters switch at different times from the cheap rate. On some smart meters, the times that switch storage heaters and hot water on and off are set separately from the times the cheap rate applies. If they don't match, heaters can run on the day rate.
  5. Backdated usage lands on the day rate. If a meter connects late or misses readings, the catch-up bill can put weeks of usage on the day rate.

How to check whether your Economy 7 is working

1. Do the "two readings" test

  1. Just before bed, write down both readings on your meter (day and night, or rate 1 and rate 2).
  2. First thing in the morning, before using much electricity, write them down again.
  3. The night reading should have gone up, especially if storage heaters or an immersion heater ran overnight. If only the day reading went up, something is wrong.

Not sure which reading is which? Read the meter twice a few hours apart during the day. The one that changed is your day rate.

2. Check your bill

You should see two rates: a day rate and a cheaper night rate. If you see only one unit rate, the meter or account may have been set up as single rate. If you see both but the night units are tiny compared with your heating use, night use may be landing on the day rate.

3. Check the times

Find your off-peak times on your bill or in your online account, and compare them with when your heaters and hot water actually come on. Our Economy 7 hours checker shows your hours for today, including the one-hour shift in summer.

What to do if something's wrong

  1. Contact your supplier and ask them to confirm three things: that your meter is set up for Economy 7 (two rates), what your off-peak times are, and, if you have storage heaters, what times the meter switches the heating circuit.
  2. Send them your readings from the two-readings test above, with dates and times. Photos of the meter display help.
  3. Ask for your account to be re-billed if night use has been charged at the day rate.
  4. Reset your timers (immersion or storage heaters) if the hours have changed. Some timers, like the Horstmann Economy 7 Quartz, need an electrician to change the off-peak setting. See our timer guide.
  5. If it isn't sorted, make a formal complaint to your supplier. If it's still not resolved after 8 weeks, or they send you a "deadlock" letter, you can take it to the Energy Ombudsman for free.
Still have an old radio-controlled (RTS) meter? The signal ended on 30 June 2026, so the meter may not switch rates or heating properly any more. Contact your supplier about a replacement.More about the RTS switch-off.

Is it worth staying on Economy 7?

If the changeover has made you rethink, use our Economy 7 calculator to compare Economy 7 with a single-rate tariff using your own usage.